EPDM Rubber Beading and Profiles are created through a systematic process. Uncured rubber is pushed through. The purpose here is to achieve the expected shape. The products are then cured in a heated autoclave. Notably, extrusions may vary, from small circular shapes to large sections in rectangular shape (from 1/8″ in diameter to a rectangular cross-section of up to 6″ by 12″). They could be produced in consistent lengths up to 60 feet. Rectangular or circular gaskets can be formed by vulcanizing splices at the corners of extrusions.
Circular or rectangular gaskets can be created from extrusions. The process requires the joining of the ends or corners using vulcanization processes, which is also known as butt or corner splicing. To know more about EPDM rubber beading and profiles, reach out to our team.
O-Ring Cord
“P” Shapes
Rectangular
Window Seal
Square
Door Seal
Odd Shapes
Valve Seal
Tubing
Gate Seal
Pads
“J” Seal
Bumpers
“T” Shapes
Channels
Office Address5-5-65/S-12A, S.A. Trade Center Ranigunj ‘X’ Road Secunderabad Telangana 500003 India.
+91 84478 25453+91 98856 34132+91 90414 21442
murtaza@deesawalarubber.comvaibhav@deesawalarubber.comWe reply within 24 hours